DeWalt Circular SawsUpdated 6 hours ago

Saw blade binds or stalls during cutting

Possible causes

• Dull or damaged blade
• Incorrect blade for the material
• Material not properly supported
• Blade depth set too deep

Resolution

• Inspect and replace dull or damaged blades.
• Use the correct blade for the material being cut.
• Support both sides of the workpiece.
• Set blade depth so only one tooth extends below the material.
• Allow the saw to reach full speed before starting the cut.

Excessive kickback

Possible causes

• Blade binding in the cut
• Twisted cutting line
• Incorrect cutting technique

Resolution

• Keep the base plate flat against the workpiece.
• Never force the saw.
• Ensure the lower guard operates freely.
• Restart a stalled cut only after centering the blade in the kerf.

Saw will not start

Possible causes

• Flat battery (cordless models)
• Damaged power cord (corded models)
• Faulty switch

Resolution

• Charge or replace battery.
• Check power supply and cable.
• If power is present and tool remains inoperative, refer for service inspection.