DeWalt Table SawsUpdated 5 hours ago

Fence not cutting parallel to blade

Possible causes

• Fence misalignment
• Locking mechanism adjustment required

Resolution

• Check fence alignment with a square.
• Adjust fence according to DeWalt fence alignment procedure.
• Recalibrate measurement scale if needed. 

Kickback during rip cuts

Possible causes

• Fence out of alignment
• Missing riving knife
• Material pinching blade

Resolution

• Verify fence is parallel.
• Ensure riving knife is installed.
• Support long material properly. 

Inaccurate measurements

Resolution

• Confirm scale calibration.
• Check fence position against blade with a rule or square.
• Re-adjust fence indicator if necessary.

Fence does not lock securely

Resolution

• Inspect locking mechanism for wear.
• Clean rails.
• Adjust locking system per service instructions.