SENCO Finish & Brad Nailer IssuesUpdated 2 hours ago

Nail Jamming

A jammed nail can prevent the tool from operating correctly.

Possible Causes

• Incorrect fasteners
• Damaged nail strip
• Dirty magazine
• Worn driver blade

Resolution

• Disconnect the tool from the air supply.
• Clear the jam following the manufacturer's instructions.
• Clean the magazine thoroughly.
• Use only compatible SENCO fasteners.

Nail Heads Standing Proud

Nails are not fully countersunk into the material.

Possible Causes

• Insufficient driving force
• Hard material density
• Incorrect depth setting
• Worn driver components

Resolution

• Adjust the depth setting.
• Increase air pressure where applicable.
• Inspect the driver blade.
• Check that the correct fastener is being used.

Misfiring

The nailer cycles but fails to drive a nail.

Possible Causes

• Empty magazine
• Worn feed pawl
• Jammed fastener
• Damaged driver blade

Resolution

• Refill the magazine.
• Inspect feed mechanisms.
• Remove any obstructions.
• Replace worn feeding components if required.