Makita Combi Drill IssuesUpdated 6 hours ago

Makita Combi Drill Problems

Chuck Slipping

A slipping chuck can prevent the drill bit from staying secure during use.

Possible Causes

• Worn chuck jaws
• Dirt or debris inside the chuck
• Incorrect bit installation
• General wear through heavy use

Resolution

• Remove the drill bit and clean inside the chuck.
• Reinstall the bit correctly and tighten securely.
• Check for visible wear on the chuck jaws.
• Replace the chuck if it no longer grips properly.

Hammer Function Not Working

The drill rotates normally but produces little or no hammer action.

Possible Causes

• Hammer mode not fully engaged
• Worn hammer mechanism
• Internal dust build-up
• Gear selector issues

Resolution

• Ensure the drill is fully switched into hammer mode.
• Rotate the mode selector through each setting a few times.
• Clean the exterior of the tool and inspect for damage.
• If the problem persists, the hammer mechanism may require servicing.

Loss of Power

The drill struggles to drill or drive fixings effectively.

Possible Causes

• Worn internal gears
• Motor wear
• Overheating protection activating
• Excessive load on the tool

Resolution

• Reduce pressure during use.
• Ensure the correct drill bit is being used.
• Allow the tool to cool if it becomes excessively hot.
• Arrange servicing if performance continues to decline.