Metabo Combi Drill IssuesUpdated 8 hours ago

Chuck Slipping

A slipping chuck can affect accuracy and make drilling difficult.

Possible Causes

• Worn chuck jaws
• Dirt or debris inside the chuck
• Incorrectly fitted drill bit
• General wear from frequent use

Resolution

• Remove the drill bit and inspect the chuck.
• Clean out any dust or debris.
• Refit the bit and tighten the chuck securely.
• Replace the chuck if it no longer grips accessories properly.

Hammer Function Not Working

The drill rotates normally but fails to produce hammer action.

Possible Causes

• Hammer mode not fully engaged
• Worn hammer mechanism
• Selector switch fault
• Internal contamination

Resolution

• Ensure the mode selector is fully engaged.
• Rotate through all operating modes several times.
• Check for visible damage to the selector switch.
• Arrange servicing if hammer mode continues to fail.

Reduced Drilling Performance

The tool struggles to drill through materials it would normally handle with ease.

Possible Causes

• Motor wear
• Gearbox wear
• Incorrect drill bit selection
• Excessive pressure during operation

Resolution

• Use a sharp, suitable drill bit.
• Allow the tool to do the work without excessive force.
• Check for unusual gearbox noises.
• Consider servicing if performance has significantly declined.